Fence Installation in Brea, CA
Legacy Fence is a licensed, bonded, and insured fence contractor (CSLB Lic. #1085306) proudly serving Brea, CA and the greater Orange County area. Whether you're looking for a more decorative look for your front yard or a low-maintenance solution for your backyard, our team installs vinyl, wood, chain link, and wrought iron fencing built to last.
Fencing Services We Offer in Brea, CA
Fence Rules & Permits in Brea, CA
Planning a new fence in Brea? Here's what the City of Brea allows, taken from Brea City Code §20.08.015, as amended by Ord. 1276; R-1 zone §20.212.040 points to it. Rules can change, so we confirm the current requirements for your address before we build.
Front Yard
In a required front yard, solid fences, walls and hedges can be up to 36 inches tall. Open fences that are at least 90% open can be up to 4.5 feet. The same limits apply within 10 feet of the street-side property line on a reversed corner lot. Fences and walls must sit at least 6 inches back from any property line along a public street.
Side & Rear Yards
Elsewhere on the lot, fences, walls and hedges can be up to 7 feet above the finished grade at the base. If the ground is regraded, finished grade is the midpoint between the highest existing grade and the highest finished grade. Lots in the HR Hillside zone follow separate retaining wall and fence rules.
Corners & Driveways
No visual obstructions are allowed in corner cut-off areas. At street corners, the cut-off line runs between points 30 feet from the corner along each property line. On each side of a driveway or alley that meets a street or alley, the cut-off line passes through a point at least 10 feet from the driveway or alley edge.
Wildfire Zones
Large parts of Brea are mapped as Very High Fire Hazard Severity Zone. Check your address on the state map and ask Building & Safety whether wildfire-zone building rules apply to your fence. Check your address on the fire zone map.
When You Need a Permit
Brea lists fences up to 6 feet tall (not concrete block, concrete or masonry) and retaining walls up to 4 feet (bottom of footing to top, not holding a surcharge) as work that may not need a building permit. The City's block wall handout says masonry or concrete fences over 30 inches tall need a building permit.
Materials & Measuring
Height is measured from the finished grade right at the base of the fence. Open-work fences count as open only if at least 90% open.
Good to Know
- HOA: If you live in an HOA, check your CC&Rs and get HOA approval before you build.
- Pools: California's Pool Safety Act requires at least two drowning-prevention safety features when a pool or spa is built or remodeled, and a pool enclosure must be at least 60 inches high.
- Hillside lots: In the HR Hillside Residential zone, retaining walls, fences and privacy walls follow separate hillside rules.
- Brush clearance: Brea's yearly brush clearance notice requires properties to be cleared of weeds and combustible debris by the posted deadline.
Height limits on a corner lot
Not sure what applies to your yard?
We check the rules for your address and your HOA before we quote, so your fence passes the first time.
Source: information checked against City of Brea sources, November 2026. This is a summary, not legal advice.
What Our Customers Say
Outstanding! We just had a 6' redwood fence installed at the back of our property. The installation team was on time, clean, efficient, incredibly fast, and really nice guys. The finished product is amazing!
From start to finish, these guys were amazing. Very responsive from the first call, friendly and knowledgeable — the fence is solid and fits in perfectly with our vintage craftsman house. I could not recommend them enough.
The Legacy Fence team were responsive, patient, professional, and accommodating. I had them install a boundary fence with my neighbor, and there were specific demands from both homeowners — they were flexible in making sure every concern was met. Definitely recommend Jose and his team!




